Key Features
1. Dual Intel® 5500 series Xeon® Quad/ Dual-Core, with QPI up to 6.4 GT/s
2. Up to 96GB DDR3 1333/ 1066/ 800MHz ECC Registered DIMM / 24GB Unbuffered DIMM
3. 1 (x4) PCI-E 2.0 (Low Profile)
4. Integrated IPMI 2.0 with KVM and Dedicated LAN
5. Intel® 82576 Dual-Port Gigabit Ethernet Controller
6. 3x Hot-swap SATA Drive Bays
7. 1400W Gold-level High-efficiency Power Supply
8. 2x PCI-E 2.0 (x16) slots (1 on each side)

Integrated Boards X8DTG-DF

Available Colors: Black    
 Drivers & Utilities       BIOS       Tested Memory List       Manuals
 

Product SKUs
SYS-6016GT-TF	SuperServer 6016GT-TF (Black)
Motherboards
Super X8DTG-DF
Processor/Cache
CPU	Dual 1366-pin LGA Sockets
	Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
	Quad-Core Intel® Xeon®Processor 5500 sequence (Nehalem-EP processor)
	NOTE: Support processors with Max TDP < 100W
QPI	up to 6.4 GT/s
System Memory
Memory Capacity	12x 240-pin DIMM sockets
	Supports up to 96 GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory
	Supports up to 24 GB 1333 / 1066 / 800MHz DDR3 ECC Unbuffered memory
	Memory Mirroring supported
Memory Type	1333 / 1066 / 800MHz ECC Registered / ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
DIMM Sizes	1GB, 2GB, 4GB, 8GB
Memory Voltage	1.5V
Error Detection	Corrects single-bit errors
	Detects double-bit errors (using ECC memory)
	Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
On-Board Devices
Chipset	Intel® 5520 (Tylersburg) chipset
	ICH10R + IOH-36D
SATA	Intel ICH10R SATA 3.0Gbps Controller
	RAID 0, 1, 5, 10 support
IPMI	Support for Intelligent Platform Management Interface v.2.0
	IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
	Winbond® WPCM450 BMC
Network Controllers	Intel® 82576 Dual-Port Gigabit Ethernet Controller
	Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
	Intel® I/OAT 3 support for fast, scaleable, and reliable networking
	VMDq support for better performance of virtualization
	1x Realtek RTL8201N PHY (dedicated IPMI)
Graphics	Matrox G200eW 8 MB DDR2
Super I/O	Winbond W83527HG chip
Clock Generator	932S421 chip
Input / Output
Serial ATA	Six Serial ATA ports
	Six SATA hard drives supported
LAN	2x RJ45 LAN ports
	1x RJ45 Dedicated IPMI LAN port
USB	2 rear + 1 header (2 Ports)
	4 total USB ports, 2.0 Compliant / 1.1 Compliant
VGA	1x VGA Port
Serial Port	1 Fast UART 16550 serial port
System BIOS
BIOS Type	32Mb SPI Flash EEPROM with AMI® BIOS
BIOS Features	Plug and Play (PnP)
	PCI 2.2
	ACPI up to 3.0
	USB Keyboard support
Chassis
Form Factor	1U Rackmount
Model	CSE-818G-1400B
Dimensions
Height	1.7" (43mm)
Width	17.2" (437mm)
Depth	28.2" (716mm)
Gross Weight	38 lbs (17.2 kg)
Available Color	Black
Front Panel
Buttons	Power On/Off button
	System Reset button
LEDs	Power LED
	Hard drive activity LED
	2x Network activity LEDs
	System Overheat LED / Fan fail LED /
	UID LED
Expansion Slots
PCI-Express	1 (x4) PCI-E 2.0 (in x16 slot -Low Profile)
	2 (x16) PCI-E 2.0 (1 in each side)
Drive Bays
Hot-swap	3x 3.5" Hot-swap SAS/SATA drive bays
Backplane
SAS/SATA HDD Backplane
System Cooling
Fans	8x 4cm heavy-duty counter-rotating PWM fans with optimal fan speed control
Power Supply
1400W high-efficiency power supply with PMBus
AC Input	1200W: 100 - 140V, 50 - 60Hz, 10.5 - 14.7 Amp
	1400W: 180 - 240V, 50 - 60Hz, 7.2 - 9.5 Amp
DC Output	4 Amp
+5V standby
DC Output	100 Amp @ 100-140V
+12V	116 Amp @ 180-240V
PC Health Monitoring
CPU	Monitors for CPU Cores,+1.5V, +3.3V, +5V, +12V, +5 Stdby, +3.3 Stdby, VBAT, Memory Voltages.
	CPU Core 6-Phase-switching voltage regulator
FAN	Total of four 4-pin PWM fans
	4x fans with tachometer monitoring
	Status monitor for speed control
	Status monitor for on/off control
	Low noise fan speed control
Temperature	Monitoring for CPU and chassis environment
	CPU thermal trip support
	Thermal Control for 4x Fan Connectors
	PSU I2C temperature sensing logic
	Thermal Monitor 2 (TM2) support
	PECI
LED	Power Fail / Overheat LED
	Suspend-state Indicator LED
	UID LED
Other Features	SDDC Support
Operating Environment / Compliance
RoHS	RoHS Compliant
Environmental Spec.	Operating Temperature: 10° to 35° C (50° to 95°F)
	Non-operating Temperature: -40° to 70° C (-40° to 158° F)
	Operating Relative Humidity: 8% to 90% (non-condensing)
	Non-operating Relative Humidity: 5 to 95% (non-condensing)