NewsletterLIÊN KẾT WEBSITE
Key Features
1. Quad Intel® Xeon® processor 7500 series, with QPI up to 6.4 GT/s
2. Up to 512GB DDR3 ECC Registered DIMM
3. Auto-switch for: 2 (x16) PCI-E 2.0 or
1 (x16) PCI-E 2.0 + 2 (x8) PCI-E 2.0 or
4 (x8) PCI-E 2.0 slots
4. Intel® 82576 Dual-Port Gigabit Ethernet Controller
5. 5 Total Hot-swap Drive Bays: 5x SAS/SATA Drives Support
6. 1400W Gold Level Redundant High-efficiency Power Supplies
7. LSI 2108 8-Port 6Gbps SAS Controller; RAID 0, 1, 5, 6, 10 Support
8. Integrated IPMI 2.0 with Dedicated LAN
  |
Integrated Boards  Super X8QB6-F |
Drivers & Utilities BIOS Tested Memory List Tested HDD List
| Product SKUs | |
| SYS-8046B-6RF | SuperServer 8046B-6RF (Black) |
| Motherboards | |
| Super X8QB6-F | |
| Processor/Cache | |
| CPU | * Quad 1567-pin LGA Sockets * Supports up to four Intel® 64-bit Xeon® processor(s) of the same type below: * Intel® Xeon® Processor 7500 Series (Nehalem-EX) - 95W |
| QPI | * up to 6.4 GT/s |
| System Memory | |
| Memory Capacity | * 32x 240-pin DIMM sockets * Supports up to 512 GB DDR3 ECC Registered memory at 1066/978/800MHz speed * Memory Mirroring supported |
| Memory Type | * 1333* / 1066 / 800MHz ECC Registered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs |
| DIMM Sizes | * 1GB, 2GB, 4GB , 8GB , 16GB |
| Memory Voltage | * 1.5 V, 1.35V |
| Error Detection | * Corrects single-bit errors * Detects double-bit errors (using ECC memory) * Supports Intel® x4 and x8 Single Device Data Correction (SDDC) |
| On-Board Devices | |
| Chipset | * Intel® 7500 (Boxboro-EX) chipset * ICH10R |
| SAS | * LSI 6Gbps SAS 2108 controller * RAID 0, 1, 5, 6, 10 support * BBU (battery backup) extension kit (optional) |
| SATA | * Intel ICH10R SATA 3.0Gbps Controller * RAID 0, 1, 5 support (Windows) * RAID 0, 1 support (Linux) |
| IPMI | * Support for Intelligent Platform Management Interface v.2.0 * IPMI 2.0 with virtual media over LAN and KVM-over-LAN support * Winbond® WPCM450 BMC |
| Network Controllers | * Intel® 82576 Dual-Port Gigabit Ethernet Controllers * Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output * 1x Realtek RTL8201N PHY (dedicated IPMI) |
| Graphics | * Matrox G200eW 16 MB DDR2 |
| Super I/O | * Winbond 83527HB chip |
| Input / Output | |
| LAN | * 3x RJ45 LAN ports |
| USB | * 2x USB rear ports * 2x USB internal headers (3 ports) * Total 5 USB 2.0 Compliant |
| VGA | * 1x VGA Port |
| Serial Port / Header | * 1 Fast UART 16550 serial port * 1 Fast UART 16550 serial header |
| System BIOS | |
| BIOS Type | * 32Mb SPI Flash EEPROM with AMI® BIOS |
| BIOS Features | * Plug and Play (PnP) * PCI 2.2 * ACPI up to 3.0 * USB Keyboard support |
| Chassis | |
| Form Factor | * Tower / 4U Rackmountable * Optional Rackmount Kit (MCP-290-00059-0B) |
| Model | * CSE-748TQ-R1400B |
| Dimensions | |
| Height | 17.8" (452mm) |
| Width | 7.0" (178mm) |
| Depth | 28.4" (721mm) |
| Weight | Gross Weight: 86.0 lbs / Net Weight: 65.5 lbs |
| Available Colors | Black |
| Front Panel | |
| Buttons | * Power On/Off button * System Reset button |
| LEDs | * Power LED * Hard drive activity LED * 2x Network activity LEDs * System Overheat LED |
| Expansion Slots | |
| PCI-Express | * Auto-switch for 2 (x16) PCI-E 2.0 or 1 (x16) PCI-E 2.0 + 2 (x8) PCI-E 2.0 or 4 (x8) PCI-E 2.0 slots |
| Drive Bays | |
| Hot-swap | * 5x 3.5" SAS / SATA Hard Drives * Additional 5x 3.5" SAS/SATA Hard Drives available with optional M35 Mobile Rack |
| Peripheral Bay(s) | * 3x 5.25" Peripheral Drive Bay |
| SATA Backplane | |
| SAS/SATA Hard Drive Backplane | |
| System Cooling | |
| Fans | * 3x 80mm RPM Hot-Swappable Cooling Fans * 3x 80mm RPM Hot-Swappable Rear Exhaust Fan |
| Shroud | * 1x Air Shroud |
| Power Supply | |
| Redundant 1400W high-efficiency power supply with PMBus | |
| AC Input | 1200W: 100 - 140V, 50 - 60Hz, 10.5 - 14.7 Amp 1400W: 180 - 240V, 50 - 60Hz, 7.2 - 9.5 Amp |
| DC Output +5V standby |
6 Amp |
| DC Output +12V |
100 Amp @ 100-140V 116 Amp @ 180-240V |
| Certification | 80 PLUS Gold Certified [ Test Report ] |
| PC Health Monitoring | |
| CPU | * Monitors for CPU Cores, +1.2V, 1.5V, +3.3V, +12V, (+3V, 1.0V, 1.2V, 1.8V, 1.1V) Standby, VBAT, Memory, Chipset Voltages. * 4-Phase-switching voltage regulator with auto-sense from 0.6V-1.35V |
| FAN | * 10x 4-pin fan headers with tachometer status monitoring * Low noise fan speed control mode |
| Temperature | * Monitoring for CPU and system environment * Thermal Control for 10x fan connectors |
| Other Features | * Chassis intrusion detection |
| Operating Environment / Compliance | |
| Environmental Spec. | * Operating Temperature: 10° to 35° C (50° to 95°F) * Non-operating Temperature: -40° to 70° C (-40° to 158° F) * Operating Relative Humidity: 8% to 90% (non-condensing) * Non-operating Relative Humidity: 5 to 95% (non-condensing) |
|
Parts List |
|||
| Parts List - (Items Included) | |||
| Part Number | Qty | Descriptin | |
| Motherboard / Chassis | MBD-X8QB6-F | 1 | Super X8QB6-F Motherboard |
| CSE-748TS-R1400BP | 1 | SC748 4U Chassis | |
| Backplane | CSE-SAS-M35TQ | 1 | M35 SAS BACKPLANE W/AMI MG9072 |
| Cable 1 | CBL-0157L-01 | 2 | 8pin to 8pin cable for SGPIO, 61.5cm, PBF |
| CD | CDR-INTC-Q | 1 | Driver for Intel quad MBs |
| Heatsink / Retention | SNK-P0045P | 4 | 2U Passive CPU Heatsink for X8QBE/6 |
| Power Distributor | PDB-PT748-8824 | 1 | OUTPUT CONNECTORS INCLUDE 24 PIN |
| Power Supply | PWS-1K41F-1R | 2 | 1400W 1U GOLD LEVEL PWS W/ PM BUS & WX106MM |
| Cable 2 | CBL-0087 | 1 | Front ctrl cable ROUND 16 TO 16 PIN RIBBON 20" |
| Cable 3 | CBL-0160L | 2 | US power cord 16AWG 6ft, PBF (default for high watt) |
| Cable 4 | CBL-0216L | 3 | 4 TO 4 PIN MIDDLE FAN POWER EXTENSION, 200MM (PWM) |
| Cable 5 | CBL-0263L | 1 | 77CM 9PIN TO 9PIN INTERNAL USB CABLE |
| Cable 6 | CBL-0286L | 3 | 4 to 4 pin rear fan pwr ext w/ square header, 30cm (PWM) |
| Fan 1 | FAN-0115L4 | 3 | 92x92x38 mm, 7.5K RPM, PWM Fan for SC748 rev K |
| Fan 2 | FAN-0116L4 | 3 | 80x80x38 mm, 8.2K RPM, PWM Fan for 748 rev K |
| Tray(s) | MCP-220-00005-00 | 3 | 5.25" drive rail set for SC743,745,748 |
| Tray(s) | MCP-220-00010-01 | 2 | Black 5.25" drive tray w/o rail (horizontal pattern) |
| Tray(s) | MCP-220-00059-0B | 1 | Black 5.25" drive tray w/o rail (FDD opening) for SC743,745 |
| Optional Parts List | |||
| Part Number | Qty | Descriptin | |
| Mounting Rails | MCP-290-00059-0B | - | 26.5" to 36.4" rail set + handles, Quick Release for 4U 17.2"W tower |
| Mobile Rack | CSE-M35T-1/CSE-M35TQ | - | Mobile Rack |
| LSI Accessory | BTR-0018L-0000-LSI | - | LSI00161 IBBU07 BATTERY BACKUP FOR SAS2108 |
| BTR-0018L-kit + CBL-0420L |
- | LSI iBBU07 extension kit | |
| 2.5" HDD Tray | MCP-220-00080-0B | - | 3.5"HDD - 2.5"HDD converter tray |
| MCP-220-00044-0N | - | Fixed dual 2.5"HDD bracket (in 5.25" bay) | |
Quảng cáo
Hỗ trợ khách hàngSản phẩm bán chạy
LIÊN KẾT WEBSITE
Giỏ hàng
